TECHNICAL DATA SHEET
XTRACON LM ALLOY 201-30
Polyurethane Alloys

       Xtracon LM Alloy 201-30 is a modified polyether urethane elastomer alloy designed for extrusion and injection molding. The material contains 30% of a proprietary ETP and is characterized by much wider process temperature profile and rapid set-up speed while maintaining excellent low temperature flexibility and the highly elastic nature of the base polyurethane. The material has excellent resistance to moisture and abrasion and would be an excellent candidate for wire and cable jacketing. LM ALLOY 201-30 exhibits minimal stress whitening and very high tensile elongation.

Flexural Modulus
psi @ 25°C		10 - 15,000
Shore A80 - 85
Melt Flow Index
190°C, 8.7 Kg. Load
10 Min, Gms.		7 - 9
Specific Gravity1.048
Tensile Strength, psi4290
Elongation @ Break, psi875
Water Content ( % )0.03


       XTRACON LM ALLOY 201-30 should be stored in a cool dry place and care should be taken to re-seal containers carefully that have been opened to avoid contamination by atmospheric moisture.

       XTRACON LM ALLOY 201-30 is not considered to be hazardous under SARA TITLE III. Safe industrial handling and hygiene practices are always highly recommended. Polyurethanes and other plastics produced with this product my present a fire hazard in certain applications if exposed to fire and/or excessive heat, e.g. welding and cutting torches in the presence of oxygen or air. Refer to MSDS for more information.

       XTRACON LM ALLOY 201-30 is available in 50 lb. bags, 1000 lb. pallets (20 bags- shrink-wrapped) or 1000 lb. Gaylord containers.


The facts stated and recommendations made herein are based on our research and research of others, and are believed to be accurate. No guarantee of their accuracy is made, however, and the product discussed is recommended without warranty on our part, express or implied, and upon conditions that recipients shall make their own test to determine its suitability for their purposes. Likewise, statements concerning the possible uses of the product are not intended as recommendations to use it in the infringement of any patent.