TECHNICAL DATA SHEET XTRACON LM ALLOY SERIES Polyurethane Alloys        Xtracon LM Alloy series are low flexural modulus (<50 kpsi) thermoplastic polymers which are blends of various urethane materials and proprietary ETP polymers. They may be used for extrusion injection molding and exhibit outstanding processing characteristics in both of these applications. Refer to individual data sheets for key physical properties and other unique attributes.        As with Xtracon concentrates, the first product number suffix designates the type of urethane used for the alloy. The remaining numbers indicate the ETP type and level. The Series Consists of Five Grades with the Following Base Resins Xtracon LM ALLOY 100-00 Polyester Urethane Xtracon LM ALLOY 200-00 Polyether Urethane Xtracon LM ALLOY 300-00 Ether/Ester Urethane Xtracon LM ALLOY 400-00 Aliphatic Polyether Urethane Xtracon LM ALLOY 500-00 Rigid Urethane Appearance 1/8” x 1/8” Pellets Color Natural Melt Flow Index 195°C, 5 Kg. Load 10 Min., Gms. 5 - 60 Water Content ( % ) 0.03 Sp. Gr. 1.00 - 1.20        XTRACON LM ALLOY Series should be stored in a cool dry place and care should be taken to re-seal containers carefully that have been opened to avoid contamination by atmospheric moisture.        XTRACON LM ALLOY Series are not considered to be hazardous under SARA TITLE III. Safe industrial handling and hygiene practices are always highly recommended. Polyurethanes and other plastics produced with this product my present a fire hazard in certain applications if exposed to fire and/or excessive heat, e.g. welding and cutting torches in the presence of oxygen or air. Refer to MSDS for more information.        XTRACON LM ALLOY Series are available in 50 lb. bags, 1000 lb. pallets (20 bags- shrink-wrapped) or 1000 lb. Gaylord containers. The facts stated and recommendations made herein are based on our research and research of others, and are believed to be accurate. No guarantee of their accuracy is made, however, and the product discussed is recommended without warranty on our part, express or implied, and upon conditions that recipients shall make their own test to determine its suitability for their purposes. Likewise, statements concerning the possible uses of the product are not intended as recommendations to use it in the infringement of any patent.